Why is my Graco sprayer not working?
60 second clip suggested2:47Basic Troubleshooting With Your Graco Paint Sprayer – YouTubeYouTubeStart of suggested clipEnd of suggested clipMake sure the suction tube is immersed into the paint. Also the inlet valve check ball may be stuckMoreMake sure the suction tube is immersed into the paint. Also the inlet valve check ball may be stuck remove. The suction tube.
Why is my Graco sprayer not building pressure?
If this is the issue you experience the most likely cause is that the transducer is worn out. The transducer signals to the airless pump that pressure is needed and signals to run the pump to build pressure. Failure to build pressure often indicates that you need to replace the transducer.
How do I add oil to my Graco sprayer?
56 second clip suggested1:46Graco Airless Paint Sprayer Maintenance (applying TSL)YouTubeStart of suggested clipEnd of suggested clipThat’s where you’re gonna want your oil to go or your throat seal. You just put it I usually put itMoreThat’s where you’re gonna want your oil to go or your throat seal. You just put it I usually put it on there until it overflows.
Why won’t my spray paint can spray?
If you continue to have problems with blocked spray paint cans, try hold the can upside down and shaking it well. When ready, apply some pressure to the nozzle and wait for the can to start spraying its contents. The pressure built up inside the can should push any blockages through and make the can useful once more.
How do you reset a paint sprayer?
60 second clip suggested1:23What to do if your Graco Magnum pump is not running – YouTubeYouTube
Why is my spray paint gun not spraying?
If your paint gun is not spraying paint at all, it’s most likely due to a clog either in the air vent hole or the hose. Clean any dried paint with a toothpick, and use a cleaning solvent to clear any remaining gunk. If you’ve cleaned your paint gun and find that it still isn’t spraying, take a look at the air supply.
Why is my Graco spray tip spitting?
First make sure the pressure isn’t set too low for the material you’re spraying. If you’re getting a combination of spitting and a broken spray pattern, the problem is likely the spray tip sizing. Prime the pump. Your Graco sprayer should have been primed too during set up to remove air from the pump.
How do you prime a Graco spray gun?
57 second clip suggested2:21How to Prime an Airless Sprayer – YouTubeYouTube
What kind of oil do you use in an airless sprayer?
FARBMAX protective oil for piston pumps and Graco TSL oil are recommended. And there you have it! All the information you need to clean your Airless Sprayer.