Which settings determine which IDE device are master and which is slave?
Look for two rows of five pins on a 3.5-inch Western Digital EIDE drive. If a jumper connects pins five and six, which are the center pins on each row, it is a master. If the jumper connects pins three and four, which are the pins second to the right, it is a slave.
How do I make my Seagate hard drive slave?
Using the arrow keys, find and select the hard drive that you attached to the computer. Change the hard drive to “Slave” status. You’ll use the “Configure” or “Change” key to do this as well. Once you see “Slave” to the right (or near) the drive’s name, you can proceed.
How do I configure a master and slave hard drive?
Steps
- Restart your computer.
- If prompted for a password, enter it and press the “Enter” key.
- Navigate to the “CMOS Setup” and press “Enter”.
- In the CMOS menu, find “Hard Disk” and then the “Primary Master” selection.
- Move the cursor to the “Primary Slave” selection and press “Enter” again.
- Edit step.
Where should pin 1 be located on the IDE controller?
The location of the 1 pin (first pin) on an IDE cable is usually designated by the red stripe on one side of the cable. In the example picture above, the 1 pin is on the right side of the cable.
What is primary IDE master and slave?
If you have a single IDE cable, with two hard drives on it one must be set to master and one to slave. The master is the first or primary, hard drive and the slave is the second, or secondary drive.
How do I make my SATA hard drive master and IDE slave?
Plug one end of a SATA data cable into the smaller L-shaped connector on the hard drive, and plug the other end into one of the SATA controllers on your computer’s motherboard. The SATA controllers are usually labeled SATA1, SATA2 and so on.
What are jumper settings on a hard drive?
The jumper pins are similar to the pins on the I/O plate on a motherboard. You enable particular settings by placing a jumper shunt onto specific pins—creating an electrical circuit between them. The settings these jumpers enable are hard-coded onto a drive’s programmed printed circuit board.
How can I use my IDE hard drive as external?
How to Connect an Internal Hard Drive Externally
- Choose an internal hard drive.
- Mount the drive into the enclosure.
- Plug in the connections.
- Seal the hard drive enclosure.
- Connect the enclosure.
- Connect the enclosure to the PC.
- Plug and play the hard drive.