What is the maximum distance that an eyewash station can be located from the work area?
55 feet
The American National Standards Institute (ANSI) recommends that any worker should be able to reach the nearest eyewash or shower station within 10 seconds of contact with the hazardous material, regardless of their physical and mental state at the time. This is often assessed as a maximum distance of 55 feet.
How far should eyewash and safety showers be located from potential hazards?
around 55 feet
The ANSI/ISEA Z358. 1 standard lays out guidelines for the location and performance of emergency eye wash and shower station. For example, safety shower and eyewash equipment must be within 10 seconds of an identified chemical hazard. This is generally equated to around 55 feet.
Where is the eyewash located?
Eyewash and Eye/Face Wash Stations The unit should be between 83.8 and 134.6 cm (33 to 53 inches) from the floor, and a minimum of 15.3 cm (6 inches) from the wall or nearest obstruction. With an eye wash station, the user should be able to open their eyelids with their hands and still have their eyes in the liquid.
How often should eyewash stations be inspected OSHA?
Inspect all eyewash units annually for compliance with the ANSI Z358. 1 standard (Section 5.5. 5). Location: The eyewash safety station must be located within 10 seconds, approximately 55 feet, from the hazard.
What are the OSHA requirements?
Know Your Rights
- Receive workplace safety and health training in a language you understand.
- Work on machines that are safe.
- Receive required safety equipment, such as gloves or a harness and lifeline for falls.
- Be protected from toxic chemicals.
- Request an OSHA inspection, and speak to the inspector.
How high should an eyewash station be mounted?
between 33 and 45 inches
Eyewash stations target just the eyes and therefore have a lower flow requirement. ANSI Z358. 1 recommends a flow of 0.4 gpm also at 30 psi. The nozzles should be at least six inches from any obstruction and mounted between 33 and 45 inches above the floor.
Is a plumbed eyewash station is portable?
Plumbed stations are permanently connected to a source of potable water, whereas portable stations are self-contained gravity-fed units with their own flushing fluid that must be replaced after each use. Eyewash fluid must irrigate and flush both eyes simultaneously.
Where should eyewash stations be placed?
Installation / Location:
- Must be accessible within 10-seconds of hazard, approximately 55-feet (consult a medical professional to determine the appropriate distance for harsh acids and caustics; high hazard = closer distance)
- Must be located on the same level as the hazard.
How do you perform an eyewash inspection?
Testing Your Eyewash Station
- Check for running water. The valve activates in a second or less and remains open until closed by user.
- Check for flow. The water stream should be about six inches long, with both streams crossing at the center of the eyewash nozzle.
- Check for balance.
- Check for temperature.
How long should eyewash stations last?
An approved eyewash station must be able to flush both eyes simultaneously, for 15 continuous minutes, with a minimum flow rate of 0.4 gallons per minute. Myth #2: “There are no specific guidelines for water temperature for an emergency eyewash or shower.”
https://www.youtube.com/watch?v=e4wApt247rs