What does a Inteli Power 9100 do?
The Inteli-Power 9100 Series is the 12 volt converter/charger of choice by leading manufacturers. These solid-state converter/chargers deliver filtered DC power to all 12 volt lighting and appliance circuits providing safe and reliable service.
What is a TCMS interface?
The built in Total Charge Management System (TCMS) connector allows the RV manufacturer, dealer, or customer to easily add the optional Charge Wizard.
How do I install Charge Wizard?
Connection
- Disconnect the 120 VAC Shore Power Cord from the RV.
- Remove the screw above the converter TCMS port.
- Push the Charge Wizard plug into the converter TCMS port.
- Reinstall the screw to hold the plug in place.
- Reconnect the Shore Power cord to 120 VAC power.
What does a Charge Wizard do?
The Charge Wizard is a microprocessor-controlled unit that constantly monitors the RV battery voltage and then selects one of three charging voltages and one of four operating modes to properly re-charge and maintain the RV battery.
How much does an RV converter cost?
The average cost of replacing an RV converter starts at about $500, which may seem steep. However, your converter is an important part of your RV’s electrical system and is worth the investment.
What is Wizard Mode button?
The Charge Wizard Operation automatically determines which operating mode is best suited to recharge or battery condition, the Wizard Mode Button allows for manual override and has indicator light(s) to indicate the mode of operation.
What is a 4 stage charger?
The charger is built to charge flooded or wet cell batteries to 100 percent by using 4-stage charging. The first stage of charge is called “bulk charge”, this is when the charger puts its full output into the batteries.
How do I know if my RV power converter is bad?
First, if the cooling fan, internal vents, or interior lights aren’t working properly, there may be an issue. Second, if you see abnormal flickering or dimming of lights on the dashboard or around the RV, it could be caused by converter problems.
What is a wizard mode button blinking?
Here’s how to decode the blinking: LIGHT “ON” AT ALL TIMES – Indicates the Charge Wizard is in the Boost Mode (Converter output voltage set to 14.4-volts) LIGHT “BLINKS” ON AND OFF FROM ONCE TO MANY TIMES A SECOND. – The Charge Wizard is in the Normal Mode (Converter output voltage set to 13.6-volts).
What is a 3 stage battery charger?
1. Three-Stage Charging – Charging using bulk charge, absorption charge, and finish charge (usually constant current – constant voltage – constant current). 2. Two-Stage Charging – Charging using bulk charge and absorption charge only (usually constant current – constant voltage). 3.