How do I reset the admin password on my brocade?

Posted on by Muna Meyer

How do I reset the admin password on my brocade?

Log in to the switch by using the serial interface or Telnet. Use the factory default accounts (root/admin/user). 16. Start the Network OS command line….Instructions

  1. Start system. (Reboots the system.)
  2. Recover password.
  3. Enter command shell: (Opens a command shell so you can reset all system passwords.)

How do I reset my SAN switch password?

Re: Recover/reset password on 8/8 SAN switch?

  1. Start system.
  2. Recover password.
  3. Enter command shell. Option?
  4. At the “>” prompt.
  5. Using the value for OSLoader, run the boot command.
  6. At the command prompt run the following commands to reset the passwords.
  7. Reboot the switch, interrupt boot agin.

How do I factory reset my Brocade 300?

Tap the “Enter” key a few times and the Brocade command prompt will display. Type the console password if requested and press the “Enter” key. Type “configDefault” and press the “Enter” key. The switch configuration is now reset to factory default settings.

How do I change the password on my Brocade switch?

Change the passwords of the accounts root, user and factoryby using SSH. At the first login you will be prompted to set new password. With ENTER you can start the process by pressing Ctrl-C you can abort the process. At the next login, you will be asked again to change the password.

How do I reset my ICX 6450 Brocade?

Resetting Brocade ICX series password:

  1. Reboot switch via console session; pay careful attention to loading prompts.
  2. Type the letter B prior to loading of flash to enter Boot Monitor mode.
  3. At prompt, simply type: no password.
  4. Reboot switch by typing: boot.

How do I change the admin password on my Brocade SAN?

including setting password rules, refer to the Security chapter of the Brocade Network OS Administrator’s Guide.

  1. Enter the configure terminal command to enter global configuration mode.
  2. Enter the username command followed by the account name and the password parameter.
  3. When prompted, enter the new password.

How do I enable root account in Brocade SAN switch?

Article Content

  1. Login via admin.
  2. Check the root access: #rootaccess –show. RootAccess : none. (when the root access isn’t allowed it would return output “none”)
  3. To allow the root access:

How do I change the root password on a Brocade switch?

Which command resets the non persistent configuration data of the HPE B series switches back to their factory default settings?

Which command resets the non-persistent configuration data of the HPE B-Series switches back to their factory-default settings (not the HPE default settings)? switchDefault switchReset configDefault factoryReset You need to reset your HPE B-Series SAN switch to the HPE default settings.

How do I enable root user in Brocade switch?