How do I fix code P1121?
The fix is replacing the valve. It’s mounted along the driver’s side frame of the engine compartment, near the radiator, and can be removed by elevating the inverter and pulling the valve out from the top.
How do I fix code P0223?
What repairs can fix the P0223 code?
- Replacing the throttle position sensor.
- Replacing the Engine Control Module.
- Plugging in, repairing, or replacing wiring that is associated with the throttle position sensor.
- Repairing or replacing the throttle body.
- Realigning the throttle position sensor.
What is the code P1122?
The P1122 is typically set when the throttle control function does not operate properly. It is common to see the throttle control motor supply voltage low due to a poor throttle motor relay. The ECM receives this voltage from the relay and distributes it to the throttle motor.
What is the coolant control valve?
Coolant switch valves control the coolant flow in side-flow cooling circuits of the powertrain and in the heating circuits of passenger compartments. In hybrid and electric vehicles, they can be used for coolant flow distribution, e.g. for cooling the battery and power electronics.
What is P0223 diagnostic code?
The P0223 code is triggered up when the voltage output from the throttle/pedal position sensor/switch to the powertrain control module is too high. These sensors are very helpful as they provide precise input from the driver’s foot in terms of how much power is required and how urgently from the engine.
How do I fix error code p1122?
26 second clip suggested0:38What is P1122 Engine Code [Quick Guide] – YouTubeYouTube
What is code P1126?
Error Code P1126 is defined as Throttle Control Motor Relay Circuit Open. This means the voltage power source for throttle control is excessively low, which could be a case of leak in the seal or the thermostat is stuck open.
How do I fix error code P2135?
What repairs can fix the P2135 code?
- Replacing one or both throttle position sensors.
- Replacing the accelerator pedal position sensor.
- Repairing a fault in a circuit (throttle position sensor circuit, accelerator pedal position sensor circuit) such as open, short, corroded wiring, or poor connection.