Are Knog lights good?
The Knog Plus light is exceptional. It does everything a commuter could want with ease, is tiny and weighs almost nothing, and is good enough for proper long winter rides too – in its longer-lived flashing modes, at least.
How do I know when Knog Blinder is charged?
No charging cable is required for your Blinder, its integrated USB plugs directly into USB ports. It has a charge time of 4 hours. When your Blinder is running low on battery, a red led will light up next to the button. This ring will turn green and then turn off once the Blinder is fully charged and ready to go.
How do you charge a Knog rear light?
USB rechargeable As with all of Knog’s bike lights the Plug is 100% rechargeable. Recharging is achieved via use of the micro USB port conveniently located behind the large rear button. Using a micro USB cable (not supplied) you can then simply recharge using any USB port.
How do you charge a Knog light?
No charging cable required, Plus plugs directly into USB ports & is designed to be exposed to the elements. Just remove from its magnetic mount and you’re ready to charge.
How do you charge a cobber light?
No charging cable is required for your Cobber, its integrated USB plugs directly into USB ports. It has a charge time of 4 hours. When your Cobber is running low on battery, a red ring will light up around the button. This ring will turn green and then turn off once the Cobber is fully charged and ready to go.
How do I turn off my Knog light?
A quick press cycles between modes, and the light remembers your previous mode when you turn it off. Another press-and-hold turns the light off.
How do I change the batteries in my Knog light?
This loosens the heat shield from the body of the light that holds the battery. Gently slide the heat shield (with the circuit board still attached) forward, and it will reveal the 18650 battery compartment (spring loaded on negative end). Remove / replace battery, and perform steps in reverse to reassemble.
Where are Knog lights made?
Australia
Knog, based in Australia, builds lights with a distinctive and stylish design using silicone rubber to encase each light and strap it onto the bike.
How do I change the battery in my Knog light?
How do you use KNOG Cobber?
Simple Button Lil’ Cobber Rear is super simple to operate. A long press of the single button will turn the light on and off, and a short press will cycle through the modes. The Lil’ Cobber has a run time of up 40 hours.
How do you charge a Cobber rear light?