Does nslookup work with IPv6?
You can use the nslookup command to display IPv6 name service information. Under your user account, run the nslookup command. The default server name and address appear, followed by the nslookup command’s angle bracket prompt.
How do I get an IPv6 address in nslookup?
In this procedure you use the nslookup command to display DNS IPv6 PTR records.
- On the command line, type the following command: % /usr/sbin/nslookup.
- To see the PTR records, type the following command at the angle bracket prompt: >set q=PTR.
- Quit the command by typing exit.
What is nslookup command in CMD?
The nslookup command queries internet domain name servers in two modes. Interactive mode allows you to query name servers for information about various hosts and domains, or to print a list of the hosts in a domain. In noninteractive mode, the names and requested information are printed for a specified host or domain.
How do I get out of nslookup?
After you update your time stamp, restart (or send a hangup to) your name server and use nslookup again, entering “quit” at the nslookup prompt will show you the reminder shown.
How can I get nslookup from IP address?
In Windows 10 and earlier, to find the IP address of another computer:
- Open a command prompt. Note:
- Type nslookup plus the domain name of the computer you want to look up, and press Enter .
- When you’re finished, type exit and press Enter to return to Windows.
Why does nslookup say server unknown?
Active Oldest Votes. 16. Nslookup will try to resolve the name for the ip address of the DNS server configured as the primary DNS server on the client by performing a reverse lookup of the ip address. If you don’t have a rDNS zone set up for your network/subnet you’ll get the “server unknown” message as nslookup will be unable to resolve
How to solve default server is unknown issue?
How to Solve Default Server is Unknown Issue For nslookup THE ERROR When you type command “nslookup” you might encounter following error stating Default Server : UnKnown SOLUTION right click reverse lookup zone and click new zone create a primary zone (by default it is already selected) type the network ID (subnet of your network)
Does nslookup still work after disabling IPv6?
After disabling IPv6 in Network Connection Settings, nslookup worked just fine. I tried running these commands from the command line, but it still did not make a difference on the nslookup:
How do I fix the default server error when performing a lookup?
THE ERROR When you type command “nslookup” you might encounter following error stating Default Server : UnKnown SOLUTION right click reverse lookup zone and click new zone create a primary zone (by default it is already selected) type the network ID (subnet of your network) Then don’t forget to select the Reverse lookup zone name:… Skip to content