How do I reset my Ruckus AP to factory settings?

Posted on by Muna Meyer

How do I reset my Ruckus AP to factory settings?

To reset your Unleashed Master AP to factory default settings:

  1. Go to Admin & Services > Administer > Backup & Restore.
  2. Click Restore to Factory Settings.
  3. Click OK to confirm.
  4. The Restoring Unleashed to factory settings progress screen appears.

How do I reset my ruckus R700 AP?

How to hard reset a Ruckus R700 (or probably any Ruckus AP for that matter)

  1. Locate the Reset pin hole on the rear panel of the AP.
  2. Power on and boot up the AP.
  3. Insert a straightened paper clip in the hole and press for at least 6 seconds.

How do I reset my ruckus r550?

Go to Admin & Services > Administer > Backup & Restore. Click Restore to Factory Settings. Click OK to confirm. The Restoring Unleashed to factory settings progress screen appears.

How do I reset my ruckus password?

If you forget your username or password, click the Forgot username or password?. To retrieve your username, contact the Ruckus Support team from here: https://support.ruckuswireless.com. To reset your password, enter your username and click Submit.

How do I reset my ruckus r310?

Try to follow below steps.

  1. Access the switch where these APs are connected and shut down the switch port for all the APs, except the master AP.
  2. Now factory reset the master AP using CLI or hardware reset button (push and hold for 12 seconds).
  3. Once above is done, shut down the switch port for this AP as well.

How do I reset my Ruckus AP via command line?

Log-in to the AP CLI using Putty application. set factory is the command to reset the Standalone AP to factory default settings.

How do I reset my ruckus ZoneDirector 1200?

You can follow those instructions to set up ZoneDirector after restoring factory defaults.

  1. Go to Administer > Backup.
  2. Locate the Restore to Factory Settings and click the button.
  3. When this factory reset process begins, you will be logged out of the web interface.