How do I know if my slave cylinder is broken?
Symptoms of a Bad Clutch Slave Cylinder
- Inability to switch gears.
- Low fluid level.
- Leaking of brake fluid.
- Clutch pedal goes all the way to the floor before working.
- Clutch pedal feels loose.
- Contaminated brake fluid.
How much does it cost to replace a slave cylinder?
The average cost for clutch slave cylinder replacement is between $206 and $245. Labor costs are estimated between $110 and $138 while parts are priced between $96 and $106. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
Where is the slave cylinder located?
The clutch slave cylinder is located on the inside or outside of the transmission. If the slave cylinder is mounted on the outside of the transmission, it is normally attached by two bolts. Every time hydraulic pressure is applied, the clutch slave cylinder has a rod that extends out to the master cylinder.
How do you check a slave cylinder on a car?
How to Test a Slave Cylinder
- Open the hood. Locate the slave cylinder.
- Look around the cylinder for wet spots that indicate it is leaking. If there is fluid coming from the cylinder, it needs to be replaced.
- Watch the cylinder as an assistant depresses the clutch pedal.
- Get in the car and start it.
How much does it cost to replace a slave cylinder on a Ford Focus?
You may also find leaked brake fluid down by the clutch pedal (inside the car)….
| Car | 2000 Ford FocusL4-2.0L |
|---|---|
| Service | Service typeClutch Master Cylinder & Slave Cylinder Replacement |
| Estimate | Estimate$373.28 |
| Shop/Dealer Price | Shop/Dealer Price$441.89 – $607.14 |
What happens when slave cylinder goes out?
The slave cylinder will often squeak when the clutch is depressed due to rust build-up or other problems. Also, if the slave cylinder is faulty, you may experience problems shifting gears. The vehicle will often slip into a gear even when the clutch is pressed, or it may not shift at all.
What happens if clutch slave cylinder fails?
Can you drive with a faulty slave cylinder?
When you cannot depress the clutch properly it can be difficult to change gears. If your clutch pedal will not raise off the floor, then the hydraulics to the clutch are not working at all. Most likely the master cylinder has gone out and will need to be replaced immediately. You cannot drive the car in this condition.
Can a clutch slave cylinder fail without leaking?
It CAN be bad without leaking fluid from the system, but not easily. That’s usually going to be form a car sitting too long or getting water in the fluid somehow to let it rust up.