How do I check my Hayward salt Cell?
Turn off the power to the system and deactivate the pool pump before removing the Turbo Cell. Remove the Turbo Cell. Once removed, look through the cell and inspect for scale formation (light colored crusty or flaky deposits) on the plates and for debris that is caught on the plates.
Why does my salt Cell say check cell?
If both the “check salt” and the “inspect cell” lights stay on, it most likely means that no chlorine is being produced at this time and your salt level fell below 2300 ppm. Both lights will also stay on if the controller is set to the wrong turbo cell type, or if the cell is unplugged.
How do you test a salt chlorinator?
On the chlorinator box there should be a light or dial that indicates it is working. Take your test kit and place your thumb over the test tube. Then place it right into the eyeball and take the water. Test the water that water has just left the chlorinator – it should have a very high chlorine reading.
How do you troubleshoot a Hayward chlorinator?
The Chlorinator Has an Air Lock An air lock inside the chlorinator can also reduce flow and chlorination. To clear an air lock, remove the lid, then turn on the pump and allow the chlorinator to fill with water. Turn off the pump; replace the lid, and turn the pump back on again.
How do I reset my Hayward salt Cell inspect cell?
Reset AquaRite Salt Chlorination Inspect Cell Light If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
How do you reset the check light on a Hayward?
You must reset the system by entering the ‘Diagnostic Menu’ and then hitting the right arrow key once and then pushing the plus key once. This should reset the light and message.