How does Ubiquiti airFiber work?
airFiber can transmit data synchronously without any wait time. Based on the ranging algorithm built into the air protocol, the airFiber radios use patent-pending HDD technology to calculate the propagation delay and know when each radio can transmit and receive, so they send packets in precise synchronization.
How to configure airFiber?
Connect Power over Ethernet to the Data port, and connect an Ethernet cable between your computer and the Management port. Configure the device settings in the airFiber Configuration Interface. Once configuration is complete, disconnect the cables to move the airFiber radios. Pre-assemble the mounting hardware.
What is a ubiquiti link?
The Ubiquiti UniFi® Building-to-Building Bridge is a 1+ Gbps Plug and Play 60 GHz Bridge with 5 GHz Radio Redundancy, UniFi Controller Management, and range of up to 500 m. The UniFi® Building-to-Building Bridge is the ideal solution for short-range, high-throughput connectivity.
How to Reset airFiber radio?
Interface Description Reset To reset to factory defaults, press and hold the Reset button for more than five seconds while the unit is powered on. Data 10/100/1000 Mbps port handles all user traffic.
How reliable is airFiber?
Resilient and reliable: AirFiber is impervious to storms that are capable of knocking out cable and phone line connections. Even during the fiercest rainstorms, you can typically expect performance to remain at 90-95%.
How do you align airFiber 5X?
Open up the alignment tool in the AirOS WebUI and have one installer slowly adjust the azimuth on one antenna until you see the signal get better, then worse again. Once you are losing signal, start backing up the azimuth until you reach the peak signal.
How do I reset my 5XHD airFiber?
Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. Signal 4 LED will light blue when on. Signal 3 LED will light green when on. Signal 2 LED will light yellow when on.
What is Air Max Ubnt?
Ubiquiti Networks™ introduced the airMAX® platform to out-perform traditional, 802.11 Wi-Fi based, Point-to-MultiPoint (PtMP), outdoor networks. As the network scales, these collisions build up exponentially, increasing latency and lowering throughput.
What is an airMAX bridge?
The Ubiquiti airMAX NanoBeams are high-performance airMAX bridges incorporating innovative industrial design with advanced technology. It’s extremely versatile and cost-effective to deploy the NanoBeam, which provides increased performance from its faster processor and innovative mechanical design at a low cost.
How do I connect airFiber 5XHD?
Connect the airFiber PoE Adapter to the Data port, and connect your computer to the MGMT port. Configure the AF-5XHD. Recommended: Install the IP67 Upgrade Kit (included) to prevent intrusion by water, dust, and insects. Install a ground wire and mount the AF-5XHD on an airFiber X or RocketDish antenna.
Is airFiber good for gaming?
Compatible with popular streaming devices and services: Rest assured that airFiber is well-suited for virtual private networks (VPNs), Voice over Internet Protocol (VoIP), static IPs, online gaming, smart TVs, tablets, and smartphones.