What is a stub tenon joint?
STUB TENON & GROOVE. Termed a stub tenon and groove, this joint is made by fitting a short tenon (usually no longer than 5/8″) into a continuous groove. This joint has the advantage of being easy to cut and is often used to make cabinet doors and other light-duty frame and panel assemblies.
What is mortise & tenon joinery?
A Primer on Joinery – The Mortise & Tenon Joinery is the process of making interlocking parts with the pieces of wood and fitting them together like a puzzle. Joints fall into two categories: Glue Only Joints -where the wood pieces are held together with just glue.
Is tongue and groove the same as mortise and tenon?
Tongue-and-groove joints are really mortise-and-tenon joints — just really, really long ones — with different component names that more accurately describe their appearance and nature. The tongue is analogous to the tenon, and is sized to exactly fit into a matching open-sided mortise, the groove.
How long is a wooden tenon?
1-1/4″ long
Tenon length: The general rule is that the minimum tenon length is five times its thickness. So a 1/4″-thick tenon should be 1-1/4″ long.
What is a lap wood joint?
A lap joint falls into the category of halving joints – where two halves make a whole. It is a relatively easy joint to cut and a great learning joint if you are just getting going in woodwork. While not particularly strong, lap joints are simple joints you can use to make picture frames and mirrors.
Should you cut the mortise or tenon first?
To make a mortise and tenon joint, always cut the mortise first because it’s much easier to cut the tenon to fit an existing mortise than the other way around.
What’s the difference between tongue and groove and dovetail?
Tongue-and-groove joints are popular for making doors, flooring, and architectural paneling. In dovetail drawer joints, the tongues look like actual dovetails, and the grooves are spaces cut to accept those pieces.
What are the advantages of a stub tenon joint?
Plus, the same cutter that makes the groove can be used to form the tenon after an easy adjustment, which Iʼll tell you about later. Other advantages of the stub-tenon joint include the ability – make that the requirement – to make either flat or raised frame-and-panel doors, and the relatively low cost and multipurpose use of the tooling required.
Can you make a stub tenon with a table saw?
Stub Tenons with a Table Saw Much of the process used for making stub tenons with a router apply to the table saw as well. In this case, however, a rip blade and stack dado set are used instead of the spline cutter.
Can you use a stub tenon door for a vanity cabinet?
But itʼs OK to use a stub-tenon door for a vanity cabinet or for a project thatʼs built as much for looks as it is for service. Once a door weighs more than four or five pounds, or is larger than 18″ x 24″, you must abandon the stub-tenon joint for a more substantial one.
How much weight can a Door weigh before a tenon joint?
Once a door weighs more than four or five pounds, or is larger than 18″ x 24″, you must abandon the stub-tenon joint for a more substantial one. Mortise-and-tenon construction, dowels, loose tenons and even biscuit joints are superior choices for larger, heavier doors.