How do you reset Microsoft Sync on Ford?

Posted on by Muna Meyer

How do you reset Microsoft Sync on Ford?

Performing a master reset

  1. Start your vehicle. Ensure your vehicle is in park and running, not in accessory mode.
  2. Press Settings on your vehicle’s SYNC screen.
  3. Choose General.
  4. Scroll down and press Master Reset.
  5. Press Continue.

How do I reset my Ford Sync 2009?

  1. Remove the navigation chip or SD card, if applicable.
  2. Touch the GEARS found on the lower right center of the home screen.
  3. Touch the SETTINGS button of the menu.
  4. Touch SYSTEM to access menu choices.
  5. Scroll down to page 2 locate MASTER RESET.
  6. Tap YES and SYNC will begin reset.

How do I reset my Ford touch screen?

To perform a System Reset, press and hold the Seek Up (>>) button while pressing and holding the Radio Power button. After approximately 5 seconds the screen will go black. Allow a 1-2 minutes for the system reset to complete. You may then resume using the SYNC system.

How do I set up my Ford Sync?

How To Set Up Your Ford SYNC®

  1. Turn on your mobile phone.
  2. Start your engine and ensure your radio is on.
  3. Access the Settings app on your smart device and enable Bluetooth as visible.
  4. Press “Phone” on your Ford SYNC® settings, and then “Add” to pair.
  5. SYNC® will prompt you to “Search for SYNC on your device”.

How do you reset the radio on a 2010 Mustang?

How To Reset A Car Radio

  1. Try disconnecting the negative terminal on your car’s battery, and leave it disconnected for almost a minute or two.
  2. If your Mustang is equipped with CD ROM, then try putting a CD in the slot.

How do I reset my Ford Sync when the screen is black?

Perform a soft reset

  1. Select Radio.
  2. Hold the Power button (center of the volume knob) + the Right-Seek button at the same time for up to 5 seconds.
  3. The display will indicate when the module is resetting. You may then release the buttons.

How do I reset my 2011 Ford Sync?

Make sure you are in a well-ventilated area.

  1. Press the PHONE hard button.
  2. Press the Down Arrow until System Settings appears on the screen and press OK.
  3. Press the Down Arrow until Advanced appears on the screen and press OK.
  4. Press the Down Arrow until Master Reset appears on the screen and press OK.
  5. Press OK to confirm.

Why is Ford Sync not working?

The USB connection to SYNC may need to be reset. Unplug the USB cable from the phone, wait a moment, and plug the USB cable back in to the phone. After a few seconds, the app should appear in SYNC’s Mobile Apps Menu. If not, “Force Close” the application and restart it.

How do I set up Bluetooth in my 2010 f150?

To connect to bluetooth, first You’ll need to turn on Your mobile device and ensure that bluetooth is enabled. Then, press the “PHONE” button to access the phone menu. Press OK. “Add a Device” will display, where You should once again press OK to confirm.