How do I reset my UVC G3 Dome?
Reset To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the camera is already powered on. microSD Reserved for future use. The UniFi Video Camera can be mounted on the wall or ceiling.
How do I reset my G4 Dome?
While the camera is powered on, press and hold the reset button for 10 seconds. Release the button (the LEDs will stop glowing). Do not disconnect the camera from its power source during the reboot process. The camera will restore factory settings after a few minutes.
How do I reset my ubiquiti NVR?
Reset Button Resets the UniFi NVR to factory defaults. The UniFi NVR must be fully booted and running. Press and hold the Reset button for about 10 seconds. The UniFi NVR will automatically reboot with default settings.
How do I reset my ubiquiti G4 camera?
Reset Button The Reset button serves two functions: • Reboot Press and release the Reset button quickly. Restore to Factory Defaults Press and hold the Reset button for 10-20 seconds while the camera is powered on. Release when LED turns off.
How do I reset my UVC G3 Micro?
Reset To reset network settings to factory defaults, press and hold the Reset button until the camera emits two short tones.
How do you reset the doorbell on a G4?
To factory reset the G4 Doorbell:
- (if the G4 Doorbell is mounted) Press the button on the bottom of the G4 Doorbell to unmount it.
- Press and hold the small rubber button at the top of the back of the G4 Doorbell for 5 seconds, then release the button.
How do you reset NVR?
To factory reset the device, hold the reset button down and unplug the NVR from power. Once power is removed from the unit, continue holding the factory reset switch for 4 – 5 seconds, continue holding the reset switch and plug the power supply back into the unit. You should hear a beep if not that is alright.
How do I reset my ubiquiti NanoStation?
Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the NanoStation is powered on. Alternatively, a remote reset button is located on the bottom of the PoE Adapter.