How much oil does a craftsman YT 4000 take?
Craftsman YT 4000 Lawn Mower User Manual Oil Capacity: W/Filter: 64 oz. W/O Filter: 60 oz. Blade Bolt Torque: 45-55 Ft.
What kind of oil does a craftsman yt4000 take?
Use 5W-30 motor oil if operating the Craftsman DYT 4000 lawnmower in temperatures below 32 degrees Fahrenheit.
How much oil does a Craftsman lawn mower take?
The 19.5 hp lawn tractors take 48 U.S. fluid ounces, or 1.5 U.S. quarts, of detergent motor oil at each oil change. The oil must conform to API service classification SF, SG or SH. When operating at air temperatures above 32 degrees Fahrenheit, use SAE 30 motor oil.
Where is oil drain plug on Craftsman riding lawn mower?
The hood on the Craftsman riding mower is hinged at the front. Open the hood to locate the oil drain plug by lifting under the rear edge near the steering wheel and raising it straight up. Once you have located the drain plug, close the hood by rotating it downwards.
How do you tell what year my Craftsman riding mower is?
Write down the first six numbers of the mower’s serial number. The first two numbers are the mower’s month of manufacture. The second two numbers indicate the day of manufacture and the third two will signify the year of manufacture.
What year is Craftsman YT 4000?
2011 Craftsman YT Series 4000.
Where is the choke on Craftsman riding mower?
It is a Craftsman riding lawn mower model DLT3000. The actual choke is located in the opening of the carburetor. It is a plate that restricts the air flow into the carburetor when the throttle lever is placed in the choke/start position.
How do you start a Craftsman riding lawn mower?
Starting
- Step 1: Place the key in the ignition switch.
- Step 2: Disengage the PTO by setting the lever to the PTO OFF position.
- Step 3: Set the parking brake.
- Step 4: Activate the choke.
- Step 5: Turn the key to START.
- Step 6: Set the throttle/choke control to FAST before you start mowing.
Where is the drain plug on a Craftsman riding mower?
To locate the plug, look down at the rear left of the mower engine. The plug, or cap, to the oil fill and drain tube is located on the rear left corner on top of the engine.