How do I stop AutoSys job?
3 Answers. Alternately, you can use term_run_time: XX (time in minutes) to terminate the job after it has run for XX minutes.
How do I use Sendevent in AutoSys?
sendevent command : to start or stop jobs, stop the AutoSys scheduler, put a job on hold, set a AutoSys global variable, cancel a scheduled jobs event and so on. Basically this command will send event in AutoSys scheduling tool.
How do I use AutoSys to find a job?
2 Answers. autorep -J %BOX_NAME% -q will spit out all jobs in a box.
How do I restart an AutoSys job?
Step 1: Put ON_HOLD job1 and job2 which are ran and completed successfully. Step 2: Terminate the box job if it is in running state. Step 3: Start the box job. step 4: Mark the job1 and job2 to success state from ON_HOLD state.
How do I turn off Autosys Jil?
JIL in Autosys
- Success – The job execution was successful with exit code “0”.
- Failure: The job failed, with exit code > 0.
- Force Start – To run the job which is not in schedule, we are forcing the start state event.
- On Hold & Off Hold – The job set to on hold will not run until it receives an off hold event.
How does Autosys verify job dependency?
Re: Autosys dependency jobs You can use the job_depends command to list a jobs dependancies, the documentation for which can be found here: https://docops.ca.com/ca-workload-automation-ae/11-4-2/en/reference/ae-commands/monitor-and-report-on-workload/job_depen… Example output: I hope this helps.
What is Sendevent?
DESCRIPTION. The sendevent utility sends mouse or keyboard events. These events are the equivalent of moving or clicking the mouse or typing keys on the keyboard.
How do I force start an Autosys job?
The recommended way to initiate a manual starting of job would be to use the autosys “sendevent” command. The sendevent command is included as part of the AE client install. The command makes use of AE environment variables to locate the $AUTOUSER/config. $AUTOSERV file.
What is Autosys Jil file?
JIL in Autosys JIL is a specification language with its own syntax which will describe how, when and where the job should run. JIL command can be entered in JIL command prompt.
What is ST status in Autosys?
Autosys Job Handling
| Code | Status |
|---|---|
| RU | Running |
| ST | Starting |
| SU | Success |
| TE | Terminated |
What is condition D in Autosys?
‘d’ (done) Indicates that the job you are defining may run when the job specified within the condition completes with a status of SUCCESS, FAILURE, or TERMINATED. ‘f’ (failure) Indicates that the job you are defining may run when the job specified within the condition completes with a status of FAILURE.
What is lookback in Autosys?
a time condition tells the successor to run again at 1:00 however 12:01 is more recent than 12:00 and lookback 0 does not validate. If the predecessor runs again at 1:30 then 1:30 is more recent than 12:01 and lookback 0 will then validate and start the second job.