Why is my Fujitsu heat pump light flashing?
If the power light is flashing, this normally means the heat pump is in defrost mode. Wait for 30 minutes and then it should start to heat again.
What is the ACL button on Fujitsu remote?
Its like a reset button. If the controller ever goes blank and the batteries are fine, press this button for a few seconds and it will power back on.
How do I turn off economy mode on Fujitsu?
To stop the test operation mode, press the START/STOP button to stop the air conditioner. CAUTION! Take care to prevent infants from acciden- tally swallowing batteries. When not using the Remote Controller for an extended period, remove the batteries to avoid possible leakage and damage to the unit.
Where is the Fujitsu error code?
When EE:EE is displayed on remote control , press “Energy Save” & “Zone Control” buttons simultaneously for longer than 3 secs. The error code will then be displayed on the LCD.
Where is reset button on Fujitsu heat pump?
You can reset your remote by using a ballpoint pen or small object to press the “Reset” or “ACL” button located on the remote control. When pushed, the screen should go blank, and when released the remote will revert to its factory setting.
Why is my Fujitsu air conditioner not working?
If your air conditioner isn’t working, please check the following: Make sure that the unit is switched on , then examine circuit breakers, to ensure power hasn’t been cut off. Your Air Conditioner, requires electricity to run, so the fix might be as simple as replacing a blown fuse or re-setting the circuit breaker.
Why is my Fujitsu Aircon not cold?
Fujitsu air conditioning problems AC runs but does not cool – May be caused by a dirty or blocked condenser or the thermostat is not properly set; this mostly happens in split systems. Run cycles are too short or too long – wrong placement of the AC can wreak havoc on your comfort, may be too close to a hot oven.