How do I reset my Whirlpool self-cleaning oven?
Reset power to the product:
- Power unit down by turning off the circuit breaker(s) for one (1) minute.
- Power unit up by turning on the circuit breaker(s).
- Start a bake cycle.
- Monitor the oven for one (1) minute to ensure the error code does not display again.
- Verify oven operation.
Why is my Whirlpool oven not self-cleaning?
A defective door switch may prevent the oven door from locking. The door switch is often part of the circuit that causes the oven door to lock during the self-cleaning cycle. If the oven door is unable to lock, the self-cleaning cycle will not start. If the door switch does not have continuity, replace it.
Did a Self-Clean on oven and now it doesn’t work?
The first step to resolving the issue is to reset your oven. If it is a wall-mounted oven, you should turn off the power to the oven at the circuit breaker and leave the power off for fifteen minutes. Wait for five minutes after restoring the power to try the oven.
Does Whirlpool oven have a reset button?
This is a soft reset and will simply get you out of any program you have started. Press it when the cooking complete reminder appears on the display, for example, and the “Your Food is Ready” message will disappear. Press the “Off/Clear’ button for three seconds to turn the “Control Locked” child lock off.
Why is my oven still locked after cleaning?
If the door will not unlock at the end of the clean cycle then you may have a problem with the oven temperature sensor. This may reset the control and allow you to unlock the door. If you still cannot unlock the door, then you can check the oven temperature sensor from the back.
Can you stop a self-cleaning oven in the middle?
You can stop a self-cleaning oven in the middle of its cleaning cycle. Press “Cancel” or “Clear/Off” to cancel the cycle. The “Stop” knob on mechanical timer models can be used to turn the oven off. If the cycle doesn’t stop, turn off the power to the range or oven at the house.
Why does my Whirlpool oven keep locking?
Loc: Whirlpool oven error code “loc” indicates that the control lock setting is activated. This setting deactivates all oven controls and locks the door. To turn the control lock setting off, press and hold the START button for 3 seconds. Turn off power to the oven and check door wiring for signs of damage.
How do you clean a self-cleaning oven that doesn’t work?
For best results, make a thin paste of 3/4 cup baking soda and 1/4 cup warm water. Remove oven racks, then coat the inside with the paste and leave it on overnight. In the morning, scrape off the paste, wipe out the oven with a damp towel and voila—a pristine oven. Cleaning the rest of your house?
Where are the fuses on my Whirlpool oven?
The thermostat fuse is located near the top middle on the back of the stove. Remove the 2 screws holding it in place.