How do I reset DD-WRT to default settings?

Posted on by Muna Meyer

How do I reset DD-WRT to default settings?

While holding down the WPS button, power on the unit….The following procedure will clear out the NVRAM and set dd-wrt back to default values:

  1. With the unit powered on, press and hold the reset button on back of unit for 30 seconds.
  2. Without releasing the reset button, unplug the unit and hold reset for another 30 seconds.

How do I restore my DD-WRT Linksys router?

Unplug the power from the router, start TFTP or the Linksys tool, and then plug the power back into the router. It should flash. Wait 3 minutes for it to finish flashing, then power cycle it and do a 30/30/30 hard reset. Be sure to use DD-WRT build 10068 or later.

How do I reset my Linksys E3000?

How do I reset the E3000 to factory defaults? Press and hold the Reset button of the E3000 located at the back of your router for 10 seconds. Alternatively, you can use the web-based setup page by going to Administration > Factory Defaults then click Restore Factory Defaults button.

How do I Unbrick my Linksys router?

Basically, hold down the reset button for 15 to 30 seconds (depending who you talk to), power off the router (while holding reset), then power back on and keep holding reset for 15 to 30 seconds. 30 seconds worked for me.

How do I reset my DD-WRT router password?

1 Answer

  1. Power the router off.
  2. Press and hold the reset button and turn the power on.
  3. Wait for the router to go into “Upgrade Mode” about 15 seconds, and release the reset button. (The power LED become white and blinks steadily)
  4. Use tftp32 to put dd-wrt or the original firmware back on the router.

How do I log into DD-WRT?

Web Interface Log into the Web-based interface to configure your DD-WRT router. Type “192.168. 1.1” into your Web browser’s address bar and press “Enter” to access the Web-based interface. Log in with the user name “root” and the password “admin” to continue.

How do I go back to stock firmware from DD-WRT?

Open upgrade page, select downloaded firmware 3. Upgrade 4. When it comes back, be sure to press reset button for 5 sec to restore dd-wrt’s factory defaults 5.

How do you do a 30 30 30 router reset?

For really difficult cases, try the “30/30/30” method: Hold down the reset button for 30 seconds, keep it pressed while you unplug the router from the power source for 30 more seconds, and then plug it back in while keeping the button held down for an additional 30 seconds.

How do I change DD-WRT firmware to original?

Remove / uninstall DD-WRT or 3rd-party firmware and revert back to the original firmware

  1. Download the proper firmware from your manufacturer’s website.
  2. Do a hard reset on the router (hold the reset button for 30 seconds, OR from the GUI, do a reset to factory defaults.

How do I reset my Linksys firmware?

Locate the Reset button and, using a pen or a paper clip, press and hold the Reset button for 10 seconds. QUICK TIP: For router models such as the Linksys Wireless-B and Wireless-G routers, press and hold the Reset button for 30 seconds. QUICK TIP: Observe the Power light of the router while pressing the button.

How do I reset Linksys router to factory settings?

1 Factory Reset

  1. Ensure the router is ON.
  2. Using a paper clip, push and hold the Reset button.
  3. Hold the reset switch for 10-15 seconds.
  4. Disconnect and reconnect the router’s power adapter.
  5. Once it fully reboots, you can use the default username and password to connect the device.