How do I use MultiWii?

Posted on by Muna Meyer

How do I use MultiWii?

Open your MultiWii folder, click on MultiwiiConf, application. windows32 (or the desired operating system’s option), and finally open MultiWiiConf.exe. On the top left of the window, select the port your flight controller is on and click on start. Sensor Values should show on the application.

What is MultiWii controller?

MultiWii is a general purpose software to control a multirotor RC model. It can now use various sensors but was initially developed to support Nintendo Wii console gyroscopes and accelerometers. The software is for the moment able to control a tricopter, a quadricopter or a hexacopter.

Can I use Arduino as a flight controller?

Our Flight Controller will be based on Arduino which will be connected to 3 Axis Gyroscope and Accelerometer Sensor and will be programmed to operate as the flight controller. We will use a simulation Software named Multiwii to calibrate and test the working of our flight controller.

What is MultiWii software?

MultiWii is an open source software project aiming to provide the brain of a RC controlled multi rotor flying platform. It is compatible with several hardware boards and sensors. The first and most famous setup is the association of a Wii Motion Plus and a Arduino pro mini board.

How do you calibrate a MultiWii drone?

Place the board or quadcopter flat on a table, plug the board into the USB connection of your computer. Startup the MultiWii Config GUI, connect to the COM port and find the ACC sensor readings. It should read close to 0 (within the range -10 to 10) for PITCH and ROLL, and close to either 256 or 512 in the Z axis.

How do you make an Arduino drone with camera?

Arduino Drone With GPS

  1. Introduction: Arduino Drone With GPS.
  2. Step 1: Gather Materials.
  3. Step 2: Assemble the Frame.
  4. Step 3: Mount Motors and Connect Escs.
  5. Step 4: Prepare Arduino and Shield.
  6. Step 5: Wire Together Components and Place Battery (Uno)
  7. Step 6: Wire Together Components and Place Battery (Mega)
  8. Step 7: Bind Receiver.

How do you calibrate ESC Multiwii?

How To:

  1. remove props or tie copter down.
  2. setup all options in config.
  3. activate the define ESC_CALIB_CANNOT_FLY, possibly set high and low values for ESC calibration, if you know what you are doing.
  4. compile, upload, run — cannot fly and will use Buzzer/LEDs to indicate finished calibration (after approx 10 seconds)